Super Service Club
23-Point Precision Tune-Up & Professional Cleaning Includes:
- Clean and wash condenser coil(s).
- Clean or replace standard air filter(s).
- Wash and level condensing unit for proper motor and bearing wear.
- Lubricate motor and fan bearing as well as other moving parts as necessary.
- Clean and inspect condensate drain lines and fittings.
- Clean, level and calibrate thermostat.
- Adjust and clean blower motor and fan assembly as needed (when accessible)
- Inspect and tighten all electrical connections, wires and terminal (includes disconnect switch).
- Clean and inspect evaporator coil and drain pan when readily accessible.
- Clean return air grills throughout house.
- Test system starting and running capacitors.
- Test all controls, switches, relays, transformers, contactors, motors, and fans.
- Measure starting and running amperes, line voltage, and control voltage.
- Test system-starting capabilities.
- Check system for proper airflow and air delivery.
- Inspect and adjust all safety controls.
- Monitor refrigerant (Freon) pressures and temperatures.
- Record super-heat and sub-cooling. Compare with factory specifications.
- Monitor fan motors and compressor operating temperatures.
- Visually inspect duct system.
- Inspect complete system for code violations and possible safety problems.
- Apply weather resistant protective coating to the outside unit (condenser).
- Complete and present full written report and make any necessary recommendations.